To download and use software for the Baofeng GT-3TP Mark III Go to product viewer dialog for this item.
Select COM Port. Choose the COM port from Device Manager (e.g., COM3).Software alone is not enough; you must have the correct hardware interface: PC-03 Programming Cable : A standard Baofeng 2-pin K-plug cable is required. USB Drivers baofeng gt-3tp mark iii software download
: This is the primary source for the GT-3 series. Look for the "UV-5 Series & GT-3 Series Programming Software" link to get the factory-standard utility. Baofeng Official To download and use software for the Baofeng
Mastering Your Baofeng GT-3TP Mark III: The Ultimate Software & Programming Guide Turn off the GT-3TP Mark III
Below are the two best options for programming your radio.
| Column | Setting | GT-3TP Specific Advice | | :--- | :--- | :--- | | | Receive frequency (MHz) | e.g., 146.520 (2m calling) | | TX Freq | Transmit frequency | Usually same as RX for simplex; different for repeaters | | Power | High / Low | In this software, High = 8W, Low = 1W. (No medium select here—adjust in menu 35 later) | | W/N | Wide / Narrow | Set to Wide for amateur bands; Narrow for GMRS or commercial | | CTCSS/DCS | Squelch tone | Enter like 100.0 or D023N | | Busy Lock | TX inhibit if channel busy | Set to OFF for ham use; ON to avoid accidental stepping |
To download and use software for the Baofeng GT-3TP Mark III Go to product viewer dialog for this item.
Select COM Port. Choose the COM port from Device Manager (e.g., COM3).Software alone is not enough; you must have the correct hardware interface: PC-03 Programming Cable : A standard Baofeng 2-pin K-plug cable is required. USB Drivers
: This is the primary source for the GT-3 series. Look for the "UV-5 Series & GT-3 Series Programming Software" link to get the factory-standard utility. Baofeng Official
Mastering Your Baofeng GT-3TP Mark III: The Ultimate Software & Programming Guide
Below are the two best options for programming your radio.
| Column | Setting | GT-3TP Specific Advice | | :--- | :--- | :--- | | | Receive frequency (MHz) | e.g., 146.520 (2m calling) | | TX Freq | Transmit frequency | Usually same as RX for simplex; different for repeaters | | Power | High / Low | In this software, High = 8W, Low = 1W. (No medium select here—adjust in menu 35 later) | | W/N | Wide / Narrow | Set to Wide for amateur bands; Narrow for GMRS or commercial | | CTCSS/DCS | Squelch tone | Enter like 100.0 or D023N | | Busy Lock | TX inhibit if channel busy | Set to OFF for ham use; ON to avoid accidental stepping |