The Bosch M7.9.7 Engine Control Unit (ECU) uses a standard 81-pin connector
| Pin | Wire Color (Typical) | Signal | Emergency Test | | :--- | :--- | :--- | :--- | | 1 | Red | Battery 12v | Check with test light (not meter) | | 11 | Black/Blue | Power Ground | Voltage drop test (<0.1v) | | 20 | Grey/Red | TPS Signal | Wiggle pedal; voltage must sweep smoothly | | 27 | Brown/White | Sensor Ground | Resistance to battery negative >10k Ohms? Bad relay. | | 29 | Green/Yellow | MAP | Blow into hose; voltage must change. | | 46 | Blue/Red | Inj 1 | "Noid" light must flash bright | | 26 | White/Red | K-Line | Scans at 10.4k baud only | | 6 | Black | Crank Sensor | 200mv AC while cranking | | 83 | Orange | 5v Reference | If missing, unplug all sensors. If it returns, one sensor is shorted. | bosch m797 pinout better
commonly found in vehicles from manufacturers like Lada, Chery, and Saipa. While the physical pinout is identical between the M7.9.7 and M7.9.7+ variants, their internal hardware differs significantly—the standard M7.9.7 uses a C167 processor with external flash memory, while the M7.9.7+ uses an ST10 processor with internal flash. Key Pin Assignments The Bosch M7
Always use a stabilized 12V power supply when connecting on a bench to avoid corrupting the EEPROM. | | 46 | Blue/Red | Inj 1