Cwfl-6000 Manual [best]

Important Clarification:

The model number CWFL-6000 typically refers to an Industrial Water Chiller manufactured by S&A (SENDA) , not a vehicle or a standard consumer electronic device. These units are commonly used to cool high-power laser machines (such as CO2 lasers, fiber lasers, or CNC spindle motors).

1. Installation: Place the chiller in a well-ventilated area with at least 30 cm of clearance around the air intake. Connect the labeled water hoses to the laser’s corresponding ports.
2. Water Filling: Open the filler cap, add the recommended coolant until the level is between the "Low" and "High" marks on the water tank sight glass.
3. Power and Configuration: Connect industrial power, power on the unit, and program the temperature parameters. The manual explains how to navigate the intelligent digital controller (often a panel with an LCD screen), setting the "Differential" (the temperature swing allowed) and the "Auto-Tuning" function.
4. Integration: For automatic operation, the manual details how to connect the chiller’s alarm and control terminals to the laser cutter’s main controller using a dry-contact relay. This allows the laser to shut down immediately if the chiller reports a flow alarm or high-temperature fault.

1. Press SET for 3 seconds until the display shows the parameter code.
2. Use the ▲/▼ buttons to navigate to F3 (High-temp target) or F4 (Low-temp target).
3. Press SET again to edit, use arrows to adjust, then press SET to save.
4. Exit by pressing SET for 3 seconds.

380V (50Hz or 60Hz)

Standard ; sensitive to voltage stability. Refrigerant cwfl-6000 manual

The CWFL-6000 operates on 380V three-phase (standard) or 220V single-phase (variant). The manual includes a detailed wiring diagram showing: Installation: Place the chiller in a well-ventilated area

• Absolute and operating ranges.
• Accuracy, precision, resolution, and latency figures with test conditions.
• Environmental ratings (temperature, humidity, ingress protection).
• EMC and emission test results.

No Dry Starts:

Never turn the machine on without water in the tank, as this will damage the pump. Press SET for 3 seconds until the display

Practical highlights:

: Includes over-current protection for the compressor, flow alarms, and ultrahigh temperature alarms. www.teyuchiller.ru Critical Operational Notices CWFL-6000 Manual - 20230104094939 | PDF - Scribd