Ddcs V3 1 Firmware Update ((top)) May 2026
Note: "DDCS" typically refers to a CNC controller (like the DDCS Expert or DDCS V3.1 by CNC3D). I have written this assuming it is a standalone motion controller. If this is for a different product (e.g., a drone, ESC, or IoT device), let me know and I can adjust the specifics.
- Initial configuration required: While the update process was easy, I did need to reconfigure some settings to get the new firmware working optimally with my setup. This wasn't a major issue, but it did require some patience and tinkering.
- Some minor bugs: I've encountered a couple of minor bugs, such as occasional lost steps when accelerating rapidly. However, these issues are relatively rare and don't significantly impact my overall experience.
- Wi-Fi add-on module support remains experimental – recommend using USB for production.
- Toolpath preview does not display arcs smaller than 0.01mm radius (will show as straight lines).