Code Vpv001-05 2021 | Doosan
“VP-V001-05”
I was unable to find specific, detailed public information about a Doosan error code labeled or “vpv001-05” .
Inspect the Solenoid Connector
: Locate the Pump P/V (A) on the main hydraulic pump. Unplug the electrical connector and check for moisture, dirt, or bent pins. doosan code vpv001-05
- VP typically stands for “Vacuum Pump” (common on Doosan machining centers with workholding vacuum systems, or on Doosan/DN Solutions multi-axis lathes with parts catchers/air systems)
- v001 might indicate a version or parameter group (possibly a PLC diagnostic bit)
- -05 often points to a specific fault condition (e.g., pressure low, timeout, motor overload)
- Locate the relay (usually a small DIN-rail mounted device labeled “Minilec” or “Crouzet”).
- Its status LEDs indicate phase loss or undervoltage. Replace if it fails to reset when voltage is restored.
To properly address this fault, we must first decode the nomenclature. Doosan’s diagnostic system uses a standardized alphanumeric structure to pinpoint issues within the Electronic Control System (ECS) and hydraulic management system. “VP-V001-05” I was unable to find specific, detailed
Diese Website benutzt Cookies, die für den technischen Betrieb der Website erforderlich sind und stets gesetzt werden. Andere Cookies, die den Komfort bei Benutzung dieser Website erhöhen, der Direktwerbung dienen oder die Interaktion mit anderen Websites und sozialen Netzwerken vereinfachen sollen, werden nur mit Ihrer Zustimmung gesetzt.