Gamepad 8710 Manual

Gamepad 8710

In the year 2042, Elias found it at the bottom of a bin in a dusty retro-tech shop: the . It was a sleek, matte-black controller with translucent buttons that pulsed with a faint, ghostly blue light. No one knew which console it belonged to, and it had no charging port.

If buttons are not working correctly:

A:

The Bluetooth chip uses a generic identifier. This is normal for unbranded units. gamepad 8710 manual

  1. Locate the USB dongle stored in the back battery compartment.
  2. Plug the dongle into your device’s USB port.
  3. Press the Home button on the controller.
  4. The LED will blink and then stay solid, indicating a successful connection.

    PC (Windows 7/8/10/11)

    The 8710 supports multiple connection methods depending on your device. Gamepad 8710 In the year 2042, Elias found

    • Solution: Most emulators allow you to remap buttons. Go to the emulator's "Input Settings" and map the buttons manually to your preference.
    1. Turn off the controller (hold HOME for 5 seconds).
    2. Press and hold L1 + R1 + HOME simultaneously for 8 seconds.
    3. The LEDs will flash three times quickly.
    4. Release. The controller is now back to original factory settings.

    Bottom edge:

    9. Common Problems & Troubleshooting

Gamepad 8710

In the year 2042, Elias found it at the bottom of a bin in a dusty retro-tech shop: the . It was a sleek, matte-black controller with translucent buttons that pulsed with a faint, ghostly blue light. No one knew which console it belonged to, and it had no charging port.

If buttons are not working correctly:

A:

The Bluetooth chip uses a generic identifier. This is normal for unbranded units.

  1. Locate the USB dongle stored in the back battery compartment.
  2. Plug the dongle into your device’s USB port.
  3. Press the Home button on the controller.
  4. The LED will blink and then stay solid, indicating a successful connection.

    PC (Windows 7/8/10/11)

    The 8710 supports multiple connection methods depending on your device.

    • Solution: Most emulators allow you to remap buttons. Go to the emulator's "Input Settings" and map the buttons manually to your preference.
    1. Turn off the controller (hold HOME for 5 seconds).
    2. Press and hold L1 + R1 + HOME simultaneously for 8 seconds.
    3. The LEDs will flash three times quickly.
    4. Release. The controller is now back to original factory settings.

    Bottom edge:

    9. Common Problems & Troubleshooting