The refers to the Gprinter GP-80160 series of 80mm thermal receipt printers . The "NCUT" designation typically distinguishes between models with an automatic cutter (Cut) and those without (No Cut). Driver & Support Overview
Setup_Full.exe file and select "Run as Administrator".: Once installed, go to Control Panel > Devices and Printers . Right-click your printer, select Printer Properties , and under the Device Settings tab, ensure the Paper Cut or Cutter option is set to "Report End" or "Document End." 4. Troubleshooting Common Issues gp80160 ncut series driver full
The driver regulates peak current via a VREF input and external sense resistors (typical 0.1 Ω). GP-80160 NCUT series The refers to the Gprinter
If Windows fails to locate the printer automatically, you can manually add it by going to Settings > Devices > Printers & Scanners and selecting "Add a printer". Port Issues: Right-click the Setup_Full
| Pin(s) | Name | Description | |--------|-------------|--------------------------------------| | 1,2 | VBB | Power supply (8–60V) | | 3,4 | GND | Power ground | | 5–8 | OUT1A,1B | H-bridge A outputs | | 9–12 | OUT2A,2B | H-bridge B outputs | | 13,14 | VCP | Charge pump capacitor connection | | 15 | nSLEEP | Sleep mode (active low) | | 16 | nFAULT | Fault output (open drain) | | 17–20 | IN1A,IN1B | Control inputs for bridge A | | 21–24 | IN2A,IN2B | Control inputs for bridge B | | 25 | MODE | Interface select (0=PH/EN, 1=PWM) | | 26 | DECAY | Decay mode setting (analog voltage) | | 27,28 | VREF | Current sense reference voltage |