Programat P90 Manual Fixed [portable] - Ivoclar

Technical Write-Up: Ivoclar Programat P90 Operation for Fixed Prosthetics

• Error messages: The device may display error messages, such as " ERR 1" or " ERR 2", indicating issues with the temperature control or heating elements.
• Temperature fluctuations: The device may experience temperature fluctuations, leading to inconsistent firing results.
• Heating element failure: The heating elements may fail, requiring replacement to restore the device's functionality.

Manual Operation

8. Technical Specifications (Corrected)

• Error E-12 or E-13: The furnace starts but aborts mid-cycle due to temperature ramp rate failures.
• Frozen Display: The LCD shows a program but buttons do not respond.
• Vacuum Failure: The auto-program stops because the vacuum pump doesn't engage, but the pump works manually.
• Corrupted User Programs: The furnace cycles through heating elements but ignores soak times.
• Post-Firmware Update Crash: The furnace boots but refuses to start any cycle.

Fix:

If you have performed the Service Mode reset, cleaned the vacuum valve, and reinstalled the firmware but the furnace still refuses to run a full sinter cycle, you likely have a hardware failure of the main control board (PCB).