Jungheinrich Etv 216 Error Codes !full! -

Jungheinrich ETV 216 Error Codes: A Comprehensive Guide

6. H850 – Drive Motor Temperature Sensor Failure

Discussion: Jungheinrich ETV 216 Error 047 - Forklift Action

2951.1

: Hydraulic function was activated during the startup sequence. 5409.1 : Battery temperature is too high. Understanding the Code Structure jungheinrich etv 216 error codes

Symptoms: Multiple random codes, display flicker, erratic operation.
Cause: CANbus bus-off condition due to bad terminating resistor or water in a junction box.
Fix: Locate the CAN junction box (behind the right cowl panel). Measure resistance between CAN-H and CAN-L: should be 60 ohms (two 120 ohm resistors in parallel). If 120 ohms, one resistor is missing. If 0 ohms, short. If infinite, open.

Error 0001 (or E0305.1):

Low voltage during system start. Check the battery charge level, the Main Current Fuse , and the main contactor. Jungheinrich ETV 216 Error Codes: A Comprehensive Guide 6

1917.1

: Simultaneous activation of the drive and brake pedals. Error 0001 (or E0305

Meaning:

The current drawn by the drive motor exceeds the controller’s safe limit.

Worn motor brushes (if DC motor) or armature short.
Binding in the drive axle or reduction gear.
Incorrect acceleration parameters after software update.