Ts1162 Installation Manual Exclusive May 2026
The Tecom TS1162 is an IP67-rated, 3-LED Remote Arming Station (RAS) designed for Challenger series control panels, utilizing RS-485 LAN connectivity and supporting distances up to 1.5 km. Installation requires addressing via DIP switches, wiring with 2-pair twisted shielded cable, and registration within the Challenger system. For detailed technical specifications, you can view the document at 34.229.59.17 Ness Corporation Ts1162 Installation Manual !exclusive!
- Check the manufacturer’s website (search for “TS1162 documentation” or “support”).
- Look for a “Downloads” or “Manuals” section.
- Contact their customer support if it’s not publicly listed.
During installation, observe the following safety precautions: ts1162 installation manual exclusive
Phase 3: The High-Frequency Step Response
I/O wiring (digital inputs/outputs, analog) The Tecom TS1162 is an IP67-rated, 3-LED Remote
- Position the Stand: Place the stand in its final location. Adjust the leveling feet on the bottom of the stand so the stand itself does not rock.
- Lower Plate: Carefully lower the granite plate onto the stand.
Correct drainage is critical to prevent water backflow and leakage. The Tecom TS1162 is an IP67-rated
Tamper Protection:
It utilizes an optical sensor for pry-off tamper detection.
- Locate the ON Tripper (usually color-coded or labeled) and the OFF Tripper.
- Loosen the screws on the trippers or snap them out (depending on the specific tripper style).
- Move the ON Tripper to the time on the dial you want the device to turn on.
- Move the OFF Tripper to the time you want the device to turn off.
- Tighten the screws securely so they do not slip.
