Xmtd-2201 Manual May 2026

Unlocking the Full Potential of Your Device: A Comprehensive Guide to the xmtd-2201 Manual

003

Enter the lock code (usually or 001 depending on the firmware) using the arrow keys, then press SET to access the parameter menu.

Output

: Relay contact (3A AC 220V resistive load) or pulse voltage (DC 0–12V) for driving Solid State Relays (SSR). xmtd-2201 manual

Sensor Input Terminals

At:

Auto-tuning. Set this to "1" to let the controller automatically calculate the best PID values for your system. 💡 Troubleshooting Common Issues Unlocking the Full Potential of Your Device: A

Autonics T4M

Industry pros often reach for this model because it’s a "set-and-forget" solution. Its automatic cold-end compensation for thermocouples ensures accuracy even as the ambient temperature in your factory fluctuates. It’s also a common alternative to other popular controllers like the or TC-3AD . Troubleshooting 101 The sensor is disconnected or broken

SCC

| Parameter | Name | Default | Description & Your Action | | :--- | :--- | :--- | :--- | | | Sensor Input Type | Varies | 0=K, 1=J, 2=E, 3=T, 4=S, 5=Pt100. Set to match your probe. | | S-H | High Limit | 400°C | Maximum allowed setpoint. | | S-L | Low Limit | -50°C | Minimum allowed setpoint. | | OP-A | Output Mode | 0 | 0 = Heating (Reverse action). 1 = Cooling (Direct action). | | P | Proportional Band | 30 | 1-999. Lower = aggressive heating. For ovens, start at 50. | | I | Integral Time | 240 sec | 1-3600. Removes steady-state error. Lower = faster, but unstable. | | D | Derivative Time | 60 sec | 0-999. Anticipates changes. Set to 0 for slow systems. | | T | Cycle Time | 20 sec | 1-100 sec. For relay output, use 15-20. For SSR, use 2-4. | | AL-1 | Alarm 1 Value | 10 | °C above SV. Set to 5 for limit alarm. | | HY-1 | Alarm Hysteresis | 2 | Prevents relay chatter. | | LOC | Lock Code | 0 | 0=Unlocked. 1=Semi-locked. 2=Fully locked. |

If you want, I can expand any section into full manual-style text (detailed pinouts, full serial command reference, wiring diagrams, or troubleshooting flowcharts).

• The sensor is disconnected or broken.
• Check wiring on terminals 1 & 2.