Safeguard Sd 103 Manual

Safeguard SD-103 — Quick User Guide

1. Initialization: Ensure the system is properly connected to the water source and power supply.
2. Pre-treatment: Adjust the pre-treatment unit settings according to the water quality parameters.
3. RO Membrane: Configure the RO membrane settings, including pressure, flow rate, and recovery rate.
4. Post-treatment: Adjust the post-treatment unit settings for final filtration and disinfection.
5. Monitoring: Continuously monitor the system's performance using the control panel.

Part 6: Troubleshooting – Solving Common SD 103 Errors

• Uneven Evaporation: Usually caused by clogged needles or uneven gas distribution. Check the flow meter and clean needles.
• Bumping/Splashing: This occurs if the gas flow is too high or the needle is too close to the liquid surface. Lower the gas pressure or raise the needle height.
• Unit Not Heating: Check the fuse (usually located near the power inlet) and ensure the power cord is secure. If the fuse is blown, replace it with one of the same amperage.